How Much Does Wall Insulation Cost in Henderson?
Wall insulation in Henderson typically costs $1,400 to $4,200 for most single-family homes, with the average job landing near $2,600. Blown-in fiberglass or cellulose runs about $1.50 to $3.50 per square foot of wall cavity, while closed-cell spray foam climbs to $5.00 to $8.00 per square foot. A single troublesome wall, like the west-facing one above your garage, can be drilled and filled for $400 to $900.
Those are real installed prices, not teasers. What you pay depends on wall area, the material you choose, and how much the crew has to open up to reach the cavity. Below is a line-by-line breakdown of what drives the number in Henderson, plus what documentation you should walk away with when the job is done.
Key Takeaways
- Typical range: $1,400 to $4,200 for a whole-house wall job, average around $2,600.
- Cheapest option: blown-in fiberglass or cellulose, $1.50 to $3.50 per square foot.
- Most expensive: closed-cell spray foam, $5.00 to $8.00 per square foot.
- Single wall: $400 to $900 if you’re chasing one bad room, not the whole house.
- Permit: Clark County typically requires one for structural modifications and for spray foam in some cases; factor $100 to $300 into the budget when it applies.
Wall Insulation Cost Breakdown (2026)
Prices below reflect the Henderson market in 2026, installed. Labor and materials are combined so you can compare like for like.
| Scope of work | Typical price in Henderson |
|---|---|
| Single wall, blown-in fiberglass or cellulose (drill-and-fill) | $400 – $900 |
| Whole-house blown-in fiberglass, existing walls | $1,400 – $2,900 |
| Whole-house cellulose, existing walls | $1,600 – $3,200 |
| Closed-cell spray foam, existing walls (drill-and-fill or open-cavity) | $5.00 – $8.00 per sq ft; whole-house usually $3,500 – $7,500 |
| Open-cell spray foam | $3.50 – $5.50 per sq ft |
| Rigid foam board, open cavities during remodel | $2.00 – $4.50 per sq ft |
| Mineral wool batts, exposed stud bays | $2.50 – $5.00 per sq ft |
| Drywall patch and paint after drill-and-fill | $150 – $600 depending on plug count |
| Air sealing of wall penetrations and outlets before fill | $200 – $500 (often bundled) |
| Permit (when structural or spray foam requires it) | $100 – $300 |
| Blower-door test before and after | $0 – $350 when bundled with a job |
The single biggest cost driver is whether a crew has to open the wall or can work through existing access. Drill-and-fill through drywall or stucco keeps cost down but adds patch work. If walls are already open during a remodel, the labor side drops sharply because there’s nothing to cut and patch. Spray foam sits at the top of the range because it’s a two-part chemical reaction done in small passes, and a technician can only cover so much wall in a day.
For the full picture on products and methods, see our guide to Wall Insulation in Henderson.
What Affects Wall Insulation Pricing in Henderson

- Wall area, not house size. A 2,400 sq ft Henderson home with tall great-room walls might expose more cavity than a 3,000 sq ft ranch with long unbroken runs. We measure actual wall area, minus windows and doors, before we quote.
- Exterior wall type. Stucco is the dominant exterior across Henderson, including in Green Valley, Anthem and Seven Hills, and it adds time. Crews have to drill through cement stucco and mesh, then patch it cleanly. Homes that are already mid-remodel with wallboard off cost less to fill.
- Material choice. Blown-in fiberglass and cellulose are the value option; closed-cell spray foam adds an air barrier and structural stiffness but roughly doubles or triples per-square-foot cost. Mineral wool batts cost more than fiberglass but handle fire and moisture well.
- Access. Crawl spaces, second-story walls, and runs behind garages slow the crew. A single-story ranch goes faster than a two-story with a tight interior wall layout. This is where a lot of the quote-to-quote variation between Henderson contractors comes from.
- Air sealing required first. Insulation blown into a leaky wall performs like a wet jacket. Sealing top plates, outlets, and penetrations before the fill adds a line item, but it’s the difference between a real R-value and a number on a bag label. We won’t blow wall insulation over unsealed penetrations. See how this works in our home envelope overview.
- The desert you live in. Henderson summers push exterior wall surfaces well above 120°F, and a west- or south-facing wall bakes all afternoon. The thermal swing and dry air are relentless. Foam and dense-packed cellulose hold up better in that heat cycling than loose fiberglass, which settles over time. A wall facing the sunset in MacDonald Ranch takes a harder beating than a shaded one in Calico Ridge, and product choice should reflect it.
How to Save on Wall Insulation in Henderson
The cheapest wall insulation job is the one done right the first time. Here’s where the money actually goes and how to keep it down.
- Bundle air sealing with the fill. Doing them together costs less than two separate visits, and the blower-door numbers come out dramatically better. In a typical Henderson home, a pre-seal blower-door test might read in the low thousands of CFM50; after sealing and filling, we’ve seen it drop by 30 to 45 percent. That’s a real performance change, not a marketing claim.
- Do it during a remodel. If walls are already open for a kitchen or bath project, the drill-and-patch line item disappears. On a typical Henderson job that saves $300 to $900.
- Insulate the worst walls first. Not every wall needs spray foam. If you have one furnace of a bedroom over the garage, filling that cavity costs $400 to $900 and solves the problem. Ask for a wall-by-wall assessment rather than a whole-house quote by default.
- Get a second written estimate. Bring us any written estimate you’ve received and we’ll read it with you. This is free, and it’s a real Haven Standard offer, not a sales tactic. Two contractors can quote the same house and differ by $1,000 because one is using open-cell foam and the other closed-cell, or because one is skipping air sealing entirely.
- Ask what’s included in writing. A written price before any work starts, a written scope, and a written warranty are the baseline. If a competing quote doesn’t say, ask. Under Haven Standard: Have it in writing means exactly that: flat price, scope, and warranty before a tool comes off the truck.
If you want a number for your specific walls, call (844) 320-5338. Estimates are free, and you get a written price before anyone starts. A live person answers, 24/7.
FAQs – Wall Insulation Cost

Is wall insulation in Henderson worth the cost?
Yes, for most homes built before roughly 2010, because wall insulation is one of the highest-return upgrades per dollar. A whole-wall job at $2,000 to $3,000 typically shaves a measurable amount off summer cooling bills in Henderson, where the AC runs hard from May through September, and it pays back over several years. The bigger win is comfort: rooms stop swinging in temperature through the afternoon. Get a written estimate and a pre-job blower-door number so the improvement is measured, not guessed.
Can you insulate walls without removing drywall?
Yes. The standard method is drill-and-fill: the crew drills small holes between studs from the interior or through the exterior, blows fiberglass or cellulose into the cavity, then patches the holes. In Henderson stucco homes, crews often work from the interior to avoid matching exterior texture, though exterior access works when the finish is being replaced. A single wall takes a few hours; a whole house usually one to two days. Blown-in fiberglass runs $1.50 to $3.50 per square foot installed.
Is spray foam worth the extra cost over blown-in?
Spray foam is worth the premium when the walls need both insulation and an air barrier, or when the home is very tight and foam is the only way to seal awkward cavities. It costs $5.00 to $8.00 per square foot for closed-cell versus $1.50 to $3.50 for blown-in, so on a whole-house job that’s a $2,000 to $4,000 difference. For a standard Henderson production home, dense-packed cellulose or fiberglass plus proper air sealing often gets you most of the way at a fraction of the cost. Ask us to model it before you commit.
How much does it cost to insulate just one wall?
A single wall runs $400 to $900 in the Henderson market, depending on length, material, and whether exterior stucco patching is involved. This is the most common request we get for the wall above a garage or a sun-baked west-facing bedroom. One wall can be done in a morning, and the difference in a hot room is noticeable the same week. Call (844) 320-5338 for an exact number.
Why do Henderson quotes vary so much for the same job?
Quotes on the same house in Henderson can vary by $1,000 to $2,500, and it usually comes down to three things: whether air sealing is included, which material is specified, and whether blower-door testing is part of the job. A cheap quote that skips air sealing and blows loose fiberglass into a leaky wall isn’t cheaper; it’s a smaller scope. Bring any written estimate to us for a free second opinion and we’ll walk through the line items with you, so you’re comparing apples to apples.
Pricing reflects the Henderson market as of 2026. Envelope Insulation Henderson offers free estimates – call (844) 320-5338.
Related reading from Envelope Insulation Henderson:
- Home energy and envelope services
- Wall insulation in Henderson
- Attic insulation overview
- Blown-in insulation guide
- Spray foam insulation services
- Attic air sealing
- Home energy audit
- Insulation removal and replacement
- Crawl space encapsulation
- Radiant barrier installation
- Attic insulation in Las Vegas
- Insulation pricing in Henderson
Written by the team at Envelope Insulation Co.
What Our Customers Say
"The winter gas bill dropped by about a third. They had estimated a quarter, so they under-promised."
- Genevieve R."They air-sealed the attic floor before insulating and showed me the blower-door number before and after. The upstairs is finally the same temperature as downstairs."
- Marisol D."Crawl space encapsulation done properly. Photographs of the vapour barrier at every seam, and the damp smell in the hallway is gone."
- Ainsley P.