Fast, Reliable Blown-In Insulation Across Las Vegas
If you live in Las Vegas and your second story never drops below the thermostat setting by mid-afternoon, the attic overhead is usually the reason. We work across the northwest valley ZIPs, from the Centennial Hills tracts off the 215 to the older 89108 blocks closer in, and we know what two decades of desert summers do to the insulation a builder put in. Our Blown-In Insulation work starts with a written price and ends with a documented record. Call (844) 320-5338 and a live person answers, day or night.
Why Envelope Insulation Henderson Is Las Vegas’s Preferred Blown-In Insulation Company
Las Vegas homeowners research before they call, and that suits the way we work. Every estimate arrives as a written price with a written scope and written warranty before anyone lifts a tool, under Haven Standard Clause 1. Cold calls and “we’ll get back to you” pricing are not part of the process.
The part that matters most in this climate: we seal first, then insulate, in that order. We will not blow new fill over an unsealed attic floor. Top plates, can lights and block-wall penetrations get air-sealed before any material goes down, because blown insulation laid over open bypasses just leaves the heat gain pathways running. On applicable jobs we publish before-and-after blower-door numbers (a pressurization reading that shows, in one figure, how much air the home was losing before and after), so you can see what changed rather than take our word for it. Every visit also comes with a Documented Photo Record, and our 365-Day Done Right Promise sits behind all completed work.
Our Blown-In Insulation Services in Las Vegas

Blown-In Top-Up
Most blown-in estimates in Las Vegas are top-ups, not first installs. In the 1980s – 2000s slab-on-grade subdivisions of the northwest valley, the original attic insulation has usually been sun-baked into a compacted mat after two decades of 200°F-plus attic days, so R-value sits far below what the AC load actually needs. We air-seal the attic floor first, then blow new fill to restore a full cooling-season R-value over what’s there.
Blown-In Fiberglass
Fiberglass is the workhorse material for these shallow block-home attics, and it holds up well to the thermal cycling between scorching days and cool nights. We use Johns Manville and Knauf fiberglass depending on the target R-value and the cavity depth we’re working with. Dry Las Vegas air means moisture problems are rare here, so heat degradation and settling are the concerns we plan around, not damp.
Dense-Pack Wall Insulation
Stucco-over-block walls are the norm across Centennial Hills and the Summerlin edge, and many of them have no wall insulation at all. Dense-pack fills those cavities under pressure so the material doesn’t settle away from the top of the wall over time. On 2×4 wood-frame homes from the same era, the same approach closes the gaps that batt insulation leaves at outlets and framing.
Blown-In Cellulose
Cellulose packs tighter than fiberglass at the same depth, which helps in the shallow attic cavities common to slab-on-grade block homes where you can’t just add height. We source it from GreenFiber and treat depth and settled density as the numbers that matter. If your attic has limited truss clearance, this is often the material that gets you to target without a rebuild.
Trusted Brands We Service in Las Vegas
We install materials from Johns Manville, Knauf, CertainTeed and Rockwool, and we match the product to the attic rather than pushing whichever brand is easiest to get. We don’t stock parts or materials locally, so there’s no proprietary lock-in steering your quote toward one manufacturer. When you get a written estimate from us, the material, target R-value and installed depth are all named on the page. If you have a competing bid, bring it and we’ll read it with you under our Free Second Opinion offer. Turnaround on scheduling is quick across the Las Vegas valley.
Common Blown-In Insulation Problems We See in Las Vegas Homes

- Sun-baked, settled legacy fill. After 20-plus years of 200°F-plus attic days, original fiberglass batts collapse to an inch or two of dusty mat. The R-value you’re counting on isn’t there anymore, and the AC runs all day trying to make up for it.
- Shallow cavities in block homes. Slab-on-grade construction leaves limited attic depth, so top-ups that skip air-sealing leave the heat gain pathways open no matter how much material goes in.
- Blown fill over unsealed bypasses. In poorly vented attics, insulation blown over open top plates, can lights and block-wall penetrations lets hot attic air move straight into living space. Sealing has to come first.
- Radiant heat with nothing blocking it. Tile roofs over these attics soak up intense solar exposure, and without a radiant barrier the attic stays hot long after sunset. That’s what drives the 24/7 cooling load.
Pricing for Blown-In Insulation in Las Vegas, NV
Most blown-in top-ups in a northwest valley home of roughly 1,800 to 2,200 square feet run $2,100 to $3,600, including air sealing of top plates and penetrations before any fill goes down. Dense-pack wall insulation for a stucco-over-block home typically lands between $1,800 and $4,200 depending on wall area and access. Adding radiant-barrier foil to the truss rafters usually adds $900 to $1,800. First-install blown fiberglass in an empty attic runs about $1,700 to $3,000. What moves the number most is attic access, how much sealing is needed, and target R-value. Every quote comes as a written price before any work starts, and estimates are free.
We Also Serve Cities Near Las Vegas

We take on Blown-In Insulation in Las Vegas and the surrounding communities, including Winchester, North Las Vegas, Sunrise Manor and Paradise. The same written-price and documented-record process applies whether your home is inside the city or just past it. Call (844) 320-5338 to check scheduling in your area.
Serving Las Vegas, NV – Our Local Coverage Area
We serve Las Vegas and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Blown-In Insulation in Las Vegas

Yes, in most cases we can blow new insulation directly over the existing fill, and that’s the standard approach in these tracts. What we won’t do is blow over it without air-sealing first: top plates, can lights and penetrations get sealed before any new material goes down. The old compacted layer serves as a base, and new fiberglass or cellulose goes on top to restore the target R-value. Call (844) 320-5338 for a written price on your attic.
Because the main job here is blocking heat gain, not holding heat in. Las Vegas summers push past 100°F with intense solar exposure, and the valley’s cooling load runs around the clock, so insulation that resists heat coming down through the attic does more for your bill than anything aimed at winter. That’s why we tune attic fill to cooling-season performance and often pair it with a radiant barrier. Call (844) 320-5338 and we’ll tell you what your attic actually needs.
Yes. Stucco-over-block walls in those ZIPs often have empty cavities that need dense-pack rather than standard batts, and the shallow attic cavities limit how much blown depth fits. The thermal mass of block also behaves differently from wood frame, so the sealing strategy changes. We size the approach to the wall type before quoting. Call (844) 320-5338 for an assessment.
Usually, yes, in these slab-on-grade block homes with tile roofs. Foil stapled to the truss rafters cuts the radiant heat load that keeps the attic hot into the evening and drives the AC run time. It’s most worth it when your attic has limited depth for added blown fill, since the barrier does work that more material can’t. Ask about it on your estimate. Call (844) 320-5338 for a written price.
An attic inspection settles it, and the deciding factor is usually the condition of the existing fill. If the original material has compacted into a dusty mat but is otherwise intact and dry, a top-up over air-sealing is often the right call. If it’s contaminated, wet, or was blown over unsealed bypasses that need opening up, removal and replacement makes more sense. We put the recommendation in writing with photos. Call (844) 320-5338 to schedule.
If your Las Vegas home is running the AC hard and getting nowhere, the answer is usually overhead. We give you a written price before any work starts, seal the attic before we insulate, and leave you with a documented record and before-and-after blower-door numbers so you can see the change. Call (844) 320-5338 for a free estimate.
Written by the team at Envelope Insulation Co.