A Topside company - serving Henderson, NV

Icynene Crawl Space Encapsulation in Henderson, NV

Icynene Crawl Space Encapsulation: The Henderson Owner’s Guide

We install Icynene-compatible crawl space encapsulation in Henderson and most homes here run $1,800 to $6,500 installed, depending on square footage, liner thickness and how much ground prep the crawl needs. Sealed-first jobs are often scheduled same-day after a written scope and price are in hand. Owners usually find out the encapsulation failed the same way:
they walk into the kitchen barefoot in July, the floor is wet-dew cool, and the baseboard on the exterior wall has gone soft. Or the AC starts running longer than it did in 2019, and the smell coming up through the floor registers is earthy.

Contractor performing professional attic air sealing to improve home energy efficiency in Henderson, NV

Call (844) 320-5338

Key Takeaways

  • Icynene encapsulation is a system: liner, seam tape, termination bar, and mechanical fasteners all have to match.
  • Most Henderson crawl failures are vapor drive or seam failure, not product failure.
  • Installed price range: $1,800 to $6,500, with written scope and warranty before work starts.

Which Icynene Models This Applies To

Icynene is a spray foam manufacturer, not a liner brand. That distinction matters for compatibility. When a Henderson homeowner searches “Icynene crawl space encapsulation,” they usually mean either (a) a crawl that already has Icynene foam on the subfloor or rim joists and now needs an encapsulation liner added, or (b) an installer proposing Icynene spray foam on the crawl walls instead of a liner. Both are real jobs. Neither uses “Icynene-branded plastic.”

How to identify what you have: look for the label on the foam itself (Icynene Classic, Icynene ProSeal, Icynene ProSeal Eco/LE, LD-R-50, LD-C-50 are the common residential series). Liner specs, by contrast, live in the written scope: 10-mil, 12-mil, or 20-mil, reinforced or standard, with a stated seal tape (butyl or reinforced acrylic) and termination bar. If the paperwork doesn’t name all four, you don’t have a spec – you have a picture on a website.

OEM versus aftermarket for Icynene is genuinely a non-issue in the sense most parts pages mean it: Icynene foam is field-applied, so there’s no discrete replacement part with a serial number. What does have an OEM-vs-aftermarket decision is the encapsulation hardware: the liner, the seam tape, the mechanical fasteners, and any sump or dehumidifier components. We source liner from the manufacturers listed further down; no proprietary lock-in. We do not stock parts, and nothing is carried on a truck. Independently, Envelope Insulation Henderson is not affiliated with Icynene.

Signs Your Icynene Crawl Space Encapsulation Is Failing

professional crawl space encapsulation & vapor barrier service
Signs Your Icynene Crawl Space Encapsulation Is Failing
  • Standing water in the liner, but no leak above. The liner is doing its job holding moisture out of the soil; the missing piece is drainage. Vapor drive under Henderson’s summer ground temperatures (top 18 inches of soil regularly 95°F+ in July and August) pushes vapor up the plastic, condenses on the underside of the subfloor, and drips. A sealed-but-not-drained encapsulation fails this way in two summers.
  • Seam tape lifting at the liner joints. The 4-inch overlap is lifting because the tape was applied to dusty liner or in cold temperatures. Once one seam opens, vapor finds it and the liner grows the peel from that point.
  • Termination bar pulling away from the foundation. Usually the wrong fastener or no gasket behind the bar. Common on block foundations in older Henderson neighborhoods like Green Valley and Black Mountain, where the mortar joint isn’t flush.
  • Musty smell returning to the home upstairs. This is the diagnostic that matters. If the smell came back after a previous encapsulation, the original job treated the symptom (moisture) but not the source (open rim joist, unsealed plumbing penetrations, no mechanical dehumidification).
  • Foam peeling off the rim joist. Icynene foam that was sprayed over a wet or dusty joist lets go in sheets. Peeling foam is not a product failure; it’s a prep failure.

Replacement Cost & What’s Included

Installed prices in Henderson, all-in with labor, materials, and documented before-and-after moisture readings:

Scope Typical Installed Range
Vapor barrier only (10-mil, sealed seams, no insulation) $1,800 – $2,800
Full encapsulation, 12-mil liner, sealed and anchored $3,200 – $4,800
Full encapsulation plus Icynene or equivalent foam on rim joists and walls $4,500 – $6,500
Removal and replacement of a failed prior encapsulation $2,400 – $5,200

What drives the range: square footage, depth of crawl (access and headroom), liner mil thickness, and whether soil prep, sump, or dehumidifier hardware is included. Parts-plus-labor is written as line items; you see the liner cost, tape cost, and labor separately. Under Haven Standard Clause 1, you get a flat written price, written scope, and written warranty before anyone lifts a tool. Written price before work starts, always – Free Second Opinion on any competing written estimate. 365-Day Done Right Promise on all completed work.

Contractor performing professional attic air sealing to improve home energy efficiency in Henderson, NV

DIY or Call Us?

Technician installing blown-in attic insulation with a professional hose
DIY or Call Us?

What you can safely check yourself: take a photo of the liner at the seam, check if water is pooling on top of the plastic, check if the termination bar is loose at the top edge, and look at your monthly electric bill against the same month two years ago. Stop there. What goes wrong when homeowners try to finish this themselves: they tape seams in a crawl that’s 110°F at the joist line, the tape won’t stick, and the peel begins under their own work in one season. Or they staple liner to a rim joist that hasn’t been air sealed, which puts a vapor barrier on the wrong side of the assembly and traps moisture against wood. Or they spray Icynene over wet wood because they don’t have a moisture meter. That last one costs more to undo than the original job.

We are background-checked, uniformed technicians with up to 10 years of experience; calls are answered by a live person 24/7. Written price, written scope, documented photo record, no exceptions. Call (844) 320-5338 for a free estimate.

Get the price in writing before anything starts.A real person answers, day or night.
Call now

FAQs

Need Insulation help nationwide? Licensed & insured · within the hour response · free estimates
Call (844) 320-5338
Local Service Coverage

Request a Free Estimate in Henderson

Tell us what you need - Envelope Insulation Henderson responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Send a Text
Call Now - 24/7 Dispatch