A Topside company - serving Henderson, NV

Rockwool Radiant Barrier Installation in Henderson, NV

Rockwool Radiant Barrier Installation: The Henderson Owner’s Guide

We install Rockwool-compatible radiant barrier systems in Henderson, and most attic installations run between $1,150 and $2,400 depending on square footage, whether the attic floor needs air sealing first, and what shape your roof deck is in. We can usually schedule a measurement within a few days, and many jobs are completed in a single visit once the written price is signed. You’re probably on this page because a radiant barrier you had installed has started to show its age: foil delaminating from the substrate, a sagging sheet in the corner of the attic, or summer attic temps that have crept back up toward where they were before the barrier went in.

Technician performing attic rodent proofing and vent securing in Henderson, NV

Call (844) 320-5338

Which Rockwool Models This Applies To

Rockwool makes mineral wool insulation and fire-safety products, not radiant barrier sheeting, so most Henderson homeowners who pair these two actually have a Rockwool insulation layer (typically R-15 to R-23 batts or blown product in the attic floor) sitting under or beside a separate radiant barrier facing. The barrier itself is usually a foil-faced woven or bubble product, and that’s the component that wears out and needs replacement. When we quote the job, we look at what’s actually there: thickness of the Rockwool layer above the ceiling plane, whether a foil facing is intact or chalky, and how the barrier was stapled or taped to the rafters. Labels on Rockwool bag ends list the product name (Comfortbatt, Safe’n’Sound, Rockboard) and R-value, so take a phone photo before we arrive if you can. OEM Rockwool facing products and quality aftermarket foil-faced equivalents both work here; what matters is the emissivity rating and that the product is foil-faced, not perforated, for a radiant barrier application. We’re an independent contractor and not affiliated with Rockwool, so we’ll tell you plainly if what you have is a Rockwool-labeled facing versus a separate barrier product.

Signs Your Rockwool Radiant Barrier Installation Is Failing

professional crawl space encapsulation & vapor barrier service
Signs Your Rockwool Radiant Barrier Installation Is Failing
  • Foil delaminating from the backing. The reflective layer peels or crazes where attic heat cycles have stressed the adhesive; once the foil separates, emissivity climbs and the barrier stops reflecting.
  • Sagging or torn sheets between rafters. Staples pull through paper or bubble backing in Henderson’s dry, hot attics; a gap of more than a few inches becomes a thermal bypass that undermines the whole run.
  • Attic temperature creeping back up. If your summer attic was 118°F after installation and is now reading closer to 140°F, the reflective surface has lost its foil face or been covered by dust and debris.
  • Condensation stains or rust on the foil. Moisture migrating from the house below can condense on the foil underside in winter; rust spots mean the barrier is no longer reflective across that patch.
  • Loose tape seams and gaps at penetrations. Foil tape lifts in heat, and any gap around can lights, plumbing stacks, or the attic hatch breaks the continuous barrier you paid for.

Replacement Cost & What’s Included

Most radiant barrier installation jobs we run in Henderson fall into these ranges, with the written price locked before any work starts:

Job scope Typical installed range
Radiant barrier replacement, 1,200 – 1,600 sq ft attic $1,150 – $1,650
Radiant barrier replacement, 1,600 – 2,200 sq ft attic $1,500 – $2,100
Radiant barrier plus attic air sealing at top plates and penetrations add $450 – $900
Radiant barrier with Rockwool batt re-set and blown insulation top-off add $600 – $1,400

What drives the range: attic slope, rafter spacing (16″ vs 24″ centers changes sheet count and labor), whether the old barrier must come down before the new goes up, and whether the Rockwool insulation layer beneath needs to be lifted and reset. Under Haven Standard Clause 1, you get a flat written price, a written scope, and a written warranty before anyone lifts a tool. The 365-Day Done Right Promise applies to the install itself.

DIY or Call Us?

Technician installing blown-in attic insulation with a professional hose
DIY or Call Us?

Nothing about radiant barrier work is high-voltage or spring-loaded, so an owner with a stable ladder, a respirator, and a cool morning can safely check what’s up there: measure the attic, photograph the label ends, and note where the foil is torn. Where DIY goes wrong in Henderson is the sequencing. If the attic air sealing isn’t done first, a fresh barrier goes up over unsealed top plates and can lights, and the same moisture and heat problems return within a season. We won’t blow or lay insulation over an unsealed attic floor, and we won’t hang a radiant barrier over one either. If you want to see what your attic is actually losing, we run a before-and-after blower-door test on applicable jobs so you carry away a number, not a feeling. Call (844) 320-5338 and we’ll talk through what your attic needs.

Get the price in writing before anything starts.A real person answers, day or night.
Call now

FAQs

Need Insulation help nationwide? Licensed & insured · within the hour response · free estimates
Call (844) 320-5338
Local Service Coverage

Request a Free Estimate in Henderson

Tell us what you need - Envelope Insulation Henderson responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Send a Text
Call Now - 24/7 Dispatch