Trusted Home Energy Audit for Henderson Homeowners
If your Henderson home runs hot on the west side of the second floor and cold in the front rooms all at once, the problem is usually the building envelope, not the thermostat. A home energy audit measures where conditioned air is escaping and where heat is forcing its way in, then puts a dollar figure next to each fix so you know which ones actually pay back. Our technicians have up to 10 years of experience, and every audit ends with a written report you keep: blower-door numbers, thermal photos, and a flat price for the work if you want it done.
Most audits in Henderson are scheduled within the same week, and we answer the phone around the clock – call (844) 320-5338 and a live person picks up, day or night. Under The Haven Standard Clause 1, nothing starts until you have a written price in hand, and that includes the audit itself.
What Our Home Energy Audit Service Includes
A home energy audit is not one test. It’s a sequence of measurements that build on each other, and skipping any one of them usually means the diagnosis is wrong. Here’s what we actually run on a Henderson house, and what each piece tells us.
Blower Door Test
A blower-door test is a pressurization reading that shows, in a single number, how much air your building envelope is losing – measured in CFM50, or cubic feet per minute at 50 pascals of pressure. We mount the fan in an exterior door frame, pull the house to a standard negative pressure, and read the leakage. You need it before you spend a dollar on insulation, because if the attic floor leaks, adding insulation over it is like putting a blanket on a screen door. On applicable jobs we publish the before-and-after blower-door numbers, so the improvement shows up as a figure on paper rather than a claim in a brochure.
Thermal Imaging Inspection
Thermal imaging uses an infrared camera to show temperature differences across walls, ceilings, and around windows – the cold spots where insulation is thin or missing and the warm streaks where air is moving. It’s the fastest way to find a problem that isn’t visible from the attic hatch, like a settled patch of blown-in material over a garage ceiling or a gap behind a knee wall. We walk the images with you on site and they go into the Documented Photo Record, so there’s no argument later about what the wall looked like before anyone touched it.
Insulation Inspection
An insulation inspection measures what’s actually in the attic, walls, and rim joists, in inches and in R-value, and compares it to what a Henderson home needs for our climate. We check depth at several points because blown-in material settles unevenly and the area near the hatch is usually the thinnest. If we find batts that were compressed during a previous install, or a knee wall with nothing behind it, that gets photographed and listed with the recommended R-value to reach.
Duct Leakage Test
A duct leakage test pressurizes the duct system and measures how much of the air your unit produces never reaches a room – in our experience, a real share of it ends up in the attic or garage. It matters most on homes where one room is always stuffy while the rest of the house is fine, or where the unit runs long on mild days. We test the ducts and include the leak reading in the report, alongside the envelope numbers, because a tight house with leaky ducts still wastes money.
Brands We Service for Home Energy Audit

An energy audit is brand-agnostic in principle but not in practice. The way a home was insulated 20 years ago often tells you which manufacturer’s product is up there, and knowing how that material behaves matters when we’re deciding whether to remove it or work over the top of it. Owens Corning fiberglass batts compress in predictable ways under a decked attic floor, which changes the R-value reading you get on the gauge. Johns Manville blown-in settles at a rate we can account for when we’re measuring depth against the labeled bag count.
Knauf and Rockwool products both hold their shape differently in a vented attic, and we account for that when we recommend a top-off depth. Whether your attic holds Owens Corning, Johns Manville, Knauf, Rockwool, or a builder-grade material with no label left on it, we can read what’s there and tell you what it’s doing. Materials we install come from those manufacturers and others including CertainTeed, Icynene, Demilec, and GreenFiber – no proprietary product lock-in.
Signs You Need Home Energy Audit Right Now
- Your second floor runs 8 to 12 degrees hotter than the first. In Henderson that gap usually traces to a leaky attic floor and thin insulation over the west-facing rooms, and the afternoon sun makes it worse from May through September. An audit pinpoints which of the two is dominant before you spend money on either.
- Your power bill jumped and nothing else changed. A rate increase explains part of it, but a bill that climbs two summers in a row on the same square footage usually means the envelope is degrading – settled insulation, a failed seal around a can light, or duct tape that has let go. The blower-door number tells you how much of that jump is air loss.
- You can feel air moving near outlets, switches, or the attic hatch. That’s not a draft from a window. It’s a direct path between conditioned space and the attic, and sealing it is the cheapest fix in the report by a wide margin.
- Dust collects faster than it used to, or rooms smell musty. Air moving through an unsealed attic floor carries insulation fibers and whatever else is up there into the house. Sealing first, then insulating, is the order that stops it.
- You’re planning insulation work and want a baseline. If a contractor has quoted you blown-in without testing the envelope first, get a home energy audit in Henderson before anyone lifts a tool. We’ll never blow insulation over an unsealed attic floor, and we’ll show you why in the readings.
Our Home Energy Audit Process – Step by Step

- 1
Written price and scope before we start. We confirm the flat price for the audit in writing, list exactly which tests are included, and put a named technician on the schedule with a text when they’re on the way. No work begins without that document signed off.
- 2
Walkthrough and insulation inspection. We measure insulation depth at multiple attic and rim-joist points, check for compressed batts and missing coverage, and photograph anything we’ll need to reference later. This is where we confirm whether removal is needed or a top-off will do.
- 3
Blower-door test. We set up the door fan and record the baseline CFM50 figure, then walk the house with the system under pressure to find the actual leak paths – top plates, can lights, plumbing penetrations, and the attic hatch frame are the usual suspects in a Henderson home.
- 4
Thermal imaging and duct leakage test. The infrared camera confirms what the blower door suggested and catches what it can’t, like missing wall insulation behind a knee wall. The duct test adds its own reading for the distribution side.
- 5
Written report and Documented Photo Record. You get the readings, the photos, and a prioritized list of fixes with a written price for each. If you have a competing estimate, we’ll read it with you as a free second opinion – no pressure either way.
How Much Does Home Energy Audit Cost in Henderson?
A stand-alone home energy audit in Henderson typically runs $300 to $550 depending on square footage, how many tests you include, and whether the attic is accessible without moving stored items. A blower-door test on its own runs roughly $200 to $350, a thermal imaging walkthrough $150 to $300, and a duct leakage test $250 to $450 – bundled together, the package usually lands lower than the sum of the parts.
What moves the price: house size (a 4,200 sq ft two-story in Seven Hills takes longer than a 1,600 sq ft single-story off Warm Springs), attic and crawl space accessibility, how many HVAC zones need duct testing, and whether we’re documenting a before-and-after for work you’re planning. What doesn’t move it: the report itself, the photos, or the second-opinion read of a competing quote. Those are included.
To avoid overpaying, don’t buy a test you don’t need. If your only question is whether the attic is under-insulated, an insulation inspection gets you most of the way for less. If you’re about to spend four figures on insulation, the full audit earns its cost back the moment it catches an unsealed attic floor. Every estimate we give carries a written price, a written scope, and a written warranty before anything starts.
Home Energy Audit Near Henderson – Our Service Area

We run audits across Henderson and the surrounding valley – Whitney, Paradise, Winchester, Enterprise, and Sunrise Manor, plus Boulder City, Spring Valley, Summerlin, North Las Vegas, Las Vegas, and out toward Sandy Valley. Most Henderson addresses get a visit within a few business days, and the closer-in neighborhoods come sooner. If you’re just over the line in Paradise or up the road in Whitney, the same lead time applies.
Serving Henderson, NV – Our Local Coverage Area
We serve Henderson and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Home Energy Audit in Henderson

A home energy audit is a set of measurements – blower-door pressurization, thermal imaging, insulation depth, and duct leakage – that shows where a house is losing conditioned air and where it needs more insulation. It produces a written report with numbers, not a general opinion about efficiency. In Henderson, the audit also accounts for our specific climate: extreme summer heat, a large day-night swing, and attics that hit 140 degrees or more. That combination is why we always test before recommending any insulation work.
Most Henderson audits take two to three hours on site for a standard single-family home, plus a day or two for the written report if you want the full write-up delivered rather than walked through the same visit. A 4,000 sq ft home with multiple HVAC zones and a crawl space can stretch to four hours. We’ll give you a realistic time window when we confirm the written price, not a range that we blow past on arrival.
A full audit typically lands between $300 and $550, with individual tests ranging from about $150 to $450 depending on which ones you need. Square footage, attic accessibility, and the number of duct zones are the three factors that move the number most. Call (844) 320-5338 for an exact quote – estimates are free, and you’ll have a written price before anything starts.
Yes. We inspect, remove, and work over Owens Corning and Johns Manville material regularly, and we know how each behaves once it’s been in an attic for a decade or two. Compressed batts and settled blown-in both read low on the gauge, and we photograph the depth readings so the recommendation is tied to what’s actually up there. Whether your attic holds one of those brands or a builder-grade product with no label, we can tell you what it’s doing and what it needs.
Often, yes – Henderson audits are usually scheduled within the same week and we hold room for same-day visits when the schedule allows. A live person answers the phone 24/7, so you’re not leaving a message and waiting for a callback window. Call (844) 320-5338 and we’ll tell you honestly what’s available today.
Every completed job is covered by the 365-Day Done Right Promise – if it’s not done right, we make it right. That applies to the audit and to any insulation, air sealing, or crawl space encapsulation work that follows it. You get the written scope and the written warranty before anyone lifts a tool, and a Documented Photo Record when the crew leaves.
Clear access to the attic hatch and any crawl space door, and move stored items away from the hatch opening if you can. Close all windows and exterior doors before we arrive so the blower-door reading is accurate, and turn off any whole-house fan. If you have recent utility bills, have them handy – they help us frame the audit findings against what you’re actually paying. Beyond that, nothing special: we bring the equipment and the cameras.
Schedule Your Home Energy Audit Service in Henderson Today
If you want to know where your Henderson home is losing air before you spend money on insulation, an audit is the place to start. Call (844) 320-5338 for a free, no-obligation estimate, with a written price before any work starts. A live person answers 24/7. Our technicians have up to 10 years of experience, and you’ll walk away with the readings, the photos, and a prioritized plan you can act on now or later.
Written by the team at Envelope Insulation Co.